Clay smoking pipe bowl and stem, discovered in 2 pieces. Images show pipe in its original location within the submarine interior, stem and bowl pieces of the pipe following initial cleaning, and reconstructed pipe following conservation treatment.
Brass thimble, 1.5 cm in diameter. Images show close-up of thimble following removal from the submarine and the thimble following mechanical cleaning and thorough drying.
Wooden plank used as a bench for crew operating the crankshaft, with notches carved out to fit around the frame ring supports. Images show the third section of the bench alongside the second bench section within the submarine prior to removal and the 3 different sections of the bench after cleaning, conservation treatment with polyethylene glycol, and freeze drying. Note also the carving in the front of one of the sections, which was done by a crew member to better operate the aft ballast pump.
Cast iron cover from the starboard deadlight with rubber seal on the inside, removed from hinge on interior of the hull plate. Images show x-ray photograph of deadlight cover, deconcreted cover with rubber seal in place, and cover with rubber seal removed after conservation treatment with subcritical fluid technology.
Assortment of non-military buttons made of mother-of-pearl, all following surface cleaning and desalination. Images show seven two-holed buttons in varying conditions, four four-holed buttons in varying conditions, forward face of one no-holed button with metal shank and brass hoop back, and the reverse side of one no-holed button with metal shank and brass hoop back.
Wooden four-holed Army buttons with depressed center, made possibly from ash or similar wood. Images show buttons in varying conditions pre-conservation, four buttons showing forward face following cleaning and freeze drying treatment, and two buttons following cleaning and freeze drying treatment, one showing forward face and one showing reverse side.
Silver suspenders/braces clasp belonging to Lieutenant George E. Dixon, discovered with the straps’ rubber elastic fragments attached. Images show the clasp following removal from the submarine interior with rubber fragments still attached, close-up of reverse side of clasp with concretion partially removed by mechanical cleaning, close-up of engraved initials reading "G.E.D." on front face of clasp following mechanical cleaning, and full view of front face of the clasp following mechanical cleaning.
Wooden object, possibly a bucket or small cask, made up of staves with a solid wooden end forming the bottom. Images show some staves and wooden end of bucket in its initial location within the submarine interior sediment, staves and wooden end of bucket laid out following initial cleaning, with some staves still concreted together, and staves of bucket reconstructed with velcro bindings following conservation treatment with polyethylene glycol and freeze drying treatment.
Hammer made of wood and wrought iron, found laying against adjustable pipe wrench in the bottom of the submarine interior. Images show the initial location of the hammer on the submarine interior hull, the hammer concretion together with the pipe wrench following removal from the submarine, x-ray photograph of the hammer following separation from wrench concretion, and the hammer following partial deconcretion.
Open ended wrought iron pipe wrench. Images show heavily concreted wrench in its initial location on top of ballast block, and wrench after cleaning, deconcretion and conservation treatment with subcritical fluid technology. Second image shows the extremely fragile condition of the wrench following conservation.
